Payment & Shipping Terms:
|Recovery:||With Recuperation System||Fan:||Belt Drive Type|
|Air Flow:||Manual Damper Control||Heating:||Riello RG5S Diesel Burner|
|Grilles:||Full Grilles||Wall Panel:||PU With Coated Steel|
Full Grilles Garage Automotive Paint Booth System Manual Damper Controlled
1. With heat recuperation system, energy save and more efficiency.
2. 0.376mm coated steel with PU inside for wall panel.
3. Quality brand name centrifugal fans, belt drive type
4. Riello RG5S diesel burner with a heating productivity of 260000Kcal/h
5. Pneumatic damper for spraying to baking cycle.
6. Double layer heat exchanger.
7. The air unit group on the roof.
8. Manual damper for changing the air flow.
In painting, outside fresh air comes into the heating generators through the pre-filter system, and enters into the plenum, then filtered by ceiling filter and into the both which brings clean,
symmetrical and steady-going down airflow for spraying. After painting, Hot air goes from heating
generators to plenum, then enters room after filtered by ceiling filter, providing heat that is necessary for baking of cars surface. In the meantime, heat recuperation system start working,energy save and temperature raise fast. Afterwards, the air with little benzene will be released to the atmosphere after being filtered twice by the exhaust air filter.
|Front door||Folding door,1 set, 3folds, 3000×2600 mm(W×H), bending main door, blue.|
|Emergency door||1 sets, 800×2000 mm(W×H), white color.|
|Basement||500mm basement, quadrate steel support, full grilles, twisted steel and bar, galvanized, in the ground, no ramps, standard air deflector.|
|Wall Panels||Thickness:50mm, width:1150mm, tongue and groove structure, 0.376mm colour steel with PU insulation inside, colour: white.|
|Light||Ceiling Lights: 8Units×4Pcs=32Pcs×36W, side lights: 8Units×4Pcs=32Pcs×18W, with electronic ballasts, lighting boxes are powered coated.|
|Generator cabinet||On the top, intake from back upper, exhaust from back upper, quadrate steel frame; white coated steel covered, filled with heat preservation material inside.|
|Intake and Exhaust system||Inlet: 1×7.5KW centrifugal fan, belt drive, model: TAE-450H, air capacity for each fan: 21000m3/h.|
|Outlet: 1×7.5KW centrifugal fan, belt drive, model: TAE-450H, air capacity for each fan: 21000m3/h, with manual damper.|
|Heating system||Diesel burner RG5S, stainless steel heat exchanger, penumatic damper for spraying and baking cycle, max temp: 80 degree, heating productive: 260000Kal/h, with heat recuperator, and pipe as for spare part to change the aluminum core plate in the summer.|
|Purification system||Pre-filter, ceiling filter, fibreglass filter, pocket filter|
|Control system||Spraying, heat spraying, baking, time setting, lighting switch, failure indicator, temperature controller, power supply switch, emergency stop, hour meter, temperature limiter, pressure gauge, baking time start from the temperature up to the setting value.|
|Total Power||17KW (3×380V, 50HZ)|
|Note||With pressure sensor, if the real pressure smaller or bigger than the setting value, the fan will stop working, fix plate use the one switch on control box, client make the platform for air group,|
Contact Person: Allan